1

I found similar questions but it doesn't help me. I am struggling to peers two node and produce block. Everything works fine in rococo-local, Below is the process that I followed,

collator-node01

./target/release/parachain-template-node --collator \
  --force-authoring \
  --chain raw-parachain-chainspec.json \
  --base-path /tmp/node01 \             
  --port 50333 \
  --rpc-port 8855 \
  -- \
  --execution wasm \
  --chain rococo \
  --port 50343 \
  --rpc-port 9988

collator-node01-keys

ganesholi@Ganeshs-MacBook-Air xcav-parachain % ls /tmp/node01/chains/dev_rococo_testnet/keystore
61757261f6b199de5d8a16b958cb619723106f9ffc26c0c24d8e12e5689676d3b8cf3345 
6772616ef72f5e6c3bdc8735f7ff92855ed6d316d7beea938ddee81fc070a55ac075db9a
ganesholi@Ganeshs-MacBook-Air xcav-parachain % 

node01_logs

collator-node02

./target/release/parachain-template-node --collator \
  --force-authoring \
  --chain raw-parachain-chainspec.json \
  --base-path /tmp/node02 \             
  --port 50334 \
  --rpc-port 8856 \
  -- \
  --execution wasm \
  --chain rococo \
  --port 50344 \
  --rpc-port 9989

collator-node02-keys

ganesholi@Ganeshs-MacBook-Air xcav-parachain % ls /tmp/node02/chains/dev_rococo_testnet/keystore
6175726192a8bc80c2d3a1dad385c5e9dee9e38ee72b9576296a2815c131c166b2cc381a
6772616ed0e5832d9fddfdc16491ec11a13047cc4c00f48802c0fe32eec0ffe85b5ca3af
ganesholi@Ganeshs-MacBook-Air xcav-parachain % 

node02_logs

raw-chainspec_file

I am using Macbook AirM1 and brave browser

While running collator node I get this issue in logs terminal. Could that be the cause of this issue?

2023-11-17 08:53:01 [Parachain] ⚠️ The hardware does not meet the minimal requirements for role 'Authority'.
2
  • Did you get a slot on Rococo? Nov 17, 2023 at 5:54
  • yes 4,323 is my rococo slots @AurevoirXavier
    – Ganesh11
    Nov 17, 2023 at 7:16

1 Answer 1

0

One of the comments in the similar question you pointed is that you always have to waiting until your collator finish the syncing. If you want a faster sync you can use the flag --sync fast (See more here What's the fastest way to sync a node only keeping full state for the last N blocks? ).

If the parachain is still not producing blocks but not showing any error messages, you need to try to figure out why, usually is due to small issue with the onboarding as a parachain.

The following checklist should help avoiding the most common reasons why a parachain won't produce blocks: Our parachain doesn't produce blocks [checklist] and for more check this guide I am creating: Troubleshooting: Common Collator Issues

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.